Kswap Cold Air Intake Install Tips: Features: Silicone tube acts as an insulator from hot air exiting the radiator Fits RBC, RRC, RBB, and PRB
This intake is designed to mate to RBC, RRC, RBB, and PRB intake manifolds. One side is compatible with a PRB manifold. The other side is compatible
During the drilling procedure, it is likely that debris were deposited inside of the tube (see Figure 4). Using a damp rag or a blow gun (attached to
With the IAT sensor installed in the newly drilled hole, slide the included t-bolt clamp over the throttle body end of the intake. Next, slide the in
Mate the filter to the CAI by sliding the aluminum tube into the end of the CAI as shown in Figure 7. Since the CAI is made from silicone, it can be
The included bracket is designed to bolt to the underside of the frame rail (see Figure 9a). Bolt the bracket to the frame rail using the supplied M1
Before tightening all of the bolts, check the filter’s position and clearance with the bumper. The bracket is slotted to allow some minor adjustment
Finally, all of the bolts may be tightened to their final torques. First, tighten the t-bolt clamp on the throttle body us-ing a 10mm deep socket as
If you have any questions or comments, please email [email protected] or call us at 225-932-9588 Legal Disclaimer Users assume all cost and r
Commentaires sur ces manuels